| Step | | Procedure & Parts & Tools |
| 1 |
|
LOCATE THE MACHINE TOOL THAT WAS ATTACHED TO THE KEY RING OF YOUR MACHINE. THIS TOOL WILL BE USED TO OPEN THE MACHINE. IF YOU DO NOT HAVE THIS TOOL, YOU CAN USE A LONG FLAT TIP SCREWDRIVER. NOTE: MAKE SURE BOTH TANKS ARE EMPTY.
|
| 2 |
|
LOCATE THE LABEL ON THE LEFT SIDE OF MACHINE (STANDING IN OPERATOR POSITION). FOLLOW THE DIRECTIONS ON THE LABEL TO OPEN THE MACHINE.
|
| 3 |
|
FOLLOWING THE DIRECTIONS ON THE LABEL, INSERT THE MACHINE TOOL INTO THE MACHINE. THIS WILL UNLOCK THE TANK. RAISE THE TANK UP TO EXPOSE THE BATTERY COMPARTMENT.
|
| 4 |
|
LOCATE THE LEVELING ARM ON FRONT OF MACHINE.
|
| 5 |
|
LOCATE THE 5 BRACKETS HOLDING LEVELING ARM TO THE FRAME.
|
| 6 |
|
EACH BRACKET HAS 2 BOLTS. REMOVE THE TEN BOLTS HOLDING THE 5 BRACKETS.
| Wrench-Allen metric 6.0mm |
|
|
| 7 |
|
PULL THE LEVELING ARM FROM THE MACHINE.
|
| 8 |
|
NOTE: PULL TO REMOVE THE BRACKETS FROM THE OLD LEVELING ARM TO USE ON THE NEW LEVELING ARM. THE NEW ARM DOES NOT INCLUDE THESE BRACKETS.
|
| 9 |
|
REVERSE STEPS 2 THRU 4 TO INSTALL A NEW LEVELING ARM AND TO REASSEMBLE THE MACHINE.
|